As we speak’s Home-owner Radio Present Podcast| June 10, 2023

#Todays #Home-owner #Radio #Present #Podcast #June

This image is a split image. tHe photo on the left is of a screw being crewed into a wall with a screwdriver. The right photo is a garbage disposal.
Learn to stop nails from coming out and what ought to and shouldn’t be put down a rubbish disposal. (3 Echoes Content material Studio)

Hour 1

Hear to listen to methods to stop nails from pooping out, elevate an outside dryer vent’s peak, and extra!


Tips on how to Cease Nails from Popping Out

This image is of someone screwing a screw into a wall with a screwdriver.
Use a drywall screw as an alternative of a nail to cease nails from backing out. ( 3 Echoes Content material Studio)

A home-owner’s home was in-built 1954 and has nails backing out of the sheetrock.

She asks, “How do I repair this? Can I pound the nails again in?”

First, pounding the nails again in will solely repair them briefly. They’ll finally come out once more. However why does this occur?

In a house, there may be loads of motion, doorways slamming, folks strolling, and many others. All these actions trigger vibrations. Over time, that vibration will trigger a drywall nail to again out.

To repair this drawback, take away the nails and exchange them with screws as a result of the screws are the higher possibility. Within the Fifties, when this home was constructed, they didn’t have drywall screws, which is why nails had been used.

You don’t wish to simply take away the nail and exchange it with a screw earlier than checking if the nail is within the middle of the stud or near the middle. The stud may be the rationale it’s coming out.

So, we suggest taking a hammer and a ending nail and tapping by means of the drywall till you discover the middle of the stud. As soon as you discover the middle and pull out the nail, then drive one or two drywall screws an inch or two above the outdated nail gap. It will maintain it tight.

After changing the nail with a drywall screw, put joint compound over the screw heads and within the outdated nail gap, let it dry, sand it, and do it once more. Upon getting it crammed and sanded dry, paint it.

Right here’s a How-To video for repairing and changing the drywall nail!

The screws will maintain up very properly, and you’ll hopefully by no means have to do that course of once more!


Tips on how to Increase an Outside Dryer Vent

This image is of an outdoor dryer vent.
An out of doors dryer vent must be no less than 8 to 10 inches off the bottom. (3 Echoes Content material Studio)

A home-owner’s dryer vent runs on an exterior wall and below the brick veneer. It’s put in about an inch off the bottom as an alternative of 12 or extra. He has hassle will water stepping into the vent.

He asks, “Do you might have any suggestions for me?”

It’s doable that when the vent was initially constructed, it was the right peak off the bottom, however as time goes on and grading and landscaping may have been added, the vent received nearer to the bottom.

To make the dryer vent work effectively, you wish to have as in need of a vent as doable. So, we don’t suggest rerouting that and going by means of the soffit.

We suggest attempting to raise or lengthen the vent upwards or digging the filth across the vent to provide it more room. you possibly can additionally add a slight flip and elbow to get it off the bottom. They make a tool that curls up at 90 levels which is able to assist elevate the vent on the surface. There are a lot of dryer vent choices.

Don’t use PVC pipe as a result of the pipe can not deal with temperatures that come by means of a dryer vent. Guarantee that any equipment you employ is manufactured for outdoor dryer vents!

For security, ensure you clear your dryer vent to forestall home fires and preserve your dryer working effectively.


Hour 2

Take heed to study rubbish disposal guidelines, methods to repair a bathroom that received’t flush, methods to lay an underlayment over a tile flooring, and extra!


What You Can Put Down a Rubbish Disposal

This image is a below the sink image of a garbage disposal.
It’s acceptable to place issues down a rubbish disposal if they’re sufficiently small. (3 Echoes Content material Studio)

A home-owner and his spouse have had an ongoing disagreement about whether or not it’s okay to place scraps of meat down the rubbish disposal. They’ve septic tank disposal.

He says, “Can you agree this debate?”

It’s completely nice to have a rubbish disposal with a septic tank. Nevertheless, some septic tanks are actually good, and others are very marginal. That performs a big half within the disposal’s performance and what waste it accepts.

So, what may be put down a rubbish disposal?

In the case of rubbish disposals, you do wish to use them sparingly and never put every little thing down it. You wish to keep away from placing giant substances down.

The reply to the query can be sure, however solely small items of meat, and don’t pack it full.

Be sure you use and keep rubbish disposals accurately. It is strongly recommended to make use of chilly water to scrub waste down the drain and make sure you don’t put one thing within the rubbish disposal and never run it!

In case your rubbish disposal will get clogged, use this trick!


Tips on how to Remedy Bathroom Flushing Points

This image shows the inside of a toilet, specifically focusing on the chain and flapper.
Adjusting the chain is a straightforward repair to resolve bathroom flushing points. (3 Echoes Content material Studio)

A home-owner is struggling to get her bathroom to flush fully. She says she has to carry the deal with down till the bowl is flushed.

She desires to know, “Why does this occur, and the way can I repair it?”

There are two causes that she could also be having this drawback. One, there may be not sufficient water within the tank, which means the water stops earlier than reaching about half an inch beneath the overflow tube. That’s the place you wish to alter it.

Subsequent, you wish to be sure that if you push down the deal with, the flapper stays open to permit the flushing motion after which closes. If the chain is just too brief or too lengthy, that may stop that from taking place.

One more reason is an obstruction within the drain. If there may be an obstruction, then you definately received’t get that flushing motion as a result of it’s resisting the water going into it.

It’s almost certainly the primary drawback. This can be a quite common repair, and there are many nice restore kits on the market. Do that rapidly so that you received’t waste water!

Though fixing a bathroom may not be essentially the most glamorous type of dwelling enchancment, it’s so necessary to have a working bathroom that may keep in good condition for a very long time.

Additional Studying: Information to All of the Elements of a Bathroom Tank


Tips on how to Set up an Underlayment

This image shows a notch trowel applying a grout to a wood floor.
Be sure you use the fitting notch trowel dimension to put in an underlayment. (3 Echoes Content material Studio)

A home-owner desires to place a quarter-inch underlayment over a tile flooring.

He asks, “Do I have to nail or screw it? What do I take advantage of?”

No, you aren’t going to wish to nail by means of or screw it. You’ll have to glue it down. Perform some research and discover the fitting adhesive you want, relying on the supplies you might be utilizing. Almost definitely, will probably be in a bucket, and also you’ll use a notch trowel to put in the correct quantity.

Just be sure you learn the instructions to make sure you use the really useful notch trowel dimension. Lots of people don’t notice that the dimensions of the notch trowel must correlate with the adhesive in an effort to work properly.

To make sure there isn’t a motion when placing down the ground, use leftover blocks, bricks, or heavy objects to weigh it down a bit bit. Go away it in a single day so that it’ll dry and actually remedy properly.

There are a number of choices for underlayment. One possibility is a self-leveling underlayment. That is like actually skinny concrete. Do a skinny coat over the tile to create a clean and flat floor for a vinyl flooring to be put over.

Additional Studying: Gluing vs. Nailing Hardwood Flooring


Finest New Merchandise

StyleWell Parker Mill 4 Piece Metal Patio Set featured image The StyleWell Parker Mill 4-Piece Steel Patio Set is sturdy and long-lasting, offering you with the out of doors furnishings you may rely on. Be taught extra>>

Easy Options

This image shows a push broom cleaning a tile floor.
Use a push broom earlier than portray to take away mud and filth from partitions. (®JodiJacobson through Canva)

Push Broom Paint Prep—Previous to portray a room, it’s necessary to wash the partitions and ceiling to take away all mud, filth, and cobwebs. Right here’s a fast and straightforward means to try this: Wrap a towel across the head of a push broom, and safe it with a binder clip or pinch clamp. Then evenly mist the towel with water. Now use the towel-wrapped broom to wipe down the partitions and ceiling. The damp towel will lure any mud or filth, forsaking a clear, ready-to-paint floor. This tip additionally works nice to take away joint-compound mud from newly sanded drywall joints.

This image shows a person gluing concrete blocks together.
Use concrete blocks to create straightforward storage in your gardening instruments. (3 Echoes Content material Studio)

Straightforward-Entry Backyard-Device Storage—Most individuals retailer their garden and backyard instruments within the storage or shed by merely standing them up and leaning them within the nook. There’s nothing significantly flawed with this besides that it’s a bit messy, and it’s laborious to seize one instrument with out knocking over one other. So, right here’s a brilliant easy resolution to that drawback: Take three concrete blocks and stack them up wherever you wish to retailer your instruments. What you find yourself with is 2 deep compartments for storing long-handled instruments. The blocks are heavy sufficient that you just don’t have to fret about them falling over, regardless of what number of instruments you place in there. In case you don’t have sufficient headroom, you should utilize two blocks so you may carry the instruments out. This gives you a neat place the place your instruments are out of the way in which and simply accessible, and also you don’t have to fret about them falling over.


Additional Studying

Leave a Reply

Your email address will not be published. Required fields are marked *